Welcome guest, Login | Register

Home

X
加载中

Transient expression in tobacco plant (Nicotiana benthamiana) is used to determine the subcellular location of a protein of interest when tagged with a reporter such as green fluorescent protein (GFP), or to mass produce proteins without making transgenic plants. The root tumor bacteria, Agrobacteria, are used as medium to introduce the target gene expression cassette into benthamiana mesophyll cells.

Thanks for your further question/comment. It has been sent to the author(s) of this protocol. You will receive a notification once your question/comment is addressed again by the author(s).
Meanwhile, it would be great if you could help us to spread the word about Bio-protocol.

X

[Bio101] Infiltration of Nicotiana benthamiana Protocol for Transient Expression via Agrobacterium

Plant Science > Plant transformation > Agrobacterium
Author: Xiyan Li
Xiyan LiAffiliation: Department of Genetics, Stanford University, Stanford, USA
For correspondence: lixiyan@stanford.edu
Bio-protocol author page: a13
7/20/2011, 28980 views, 0 Q&A, How to cite
DOI: http://dx.doi.org/10.21769/BioProtoc.95

[Abstract] Transient expression in tobacco plant (Nicotiana benthamiana) is used to determine the subcellular location of a protein of interest when tagged with a reporter such as green fluorescent protein (GFP), or to mass produce proteins without making transgenic plants. The root tumor bacteria, Agrobacteria, are used as medium to introduce the target gene expression cassette into benthamiana mesophyll cells.

Keywords: Transient expression, Tobacco, Agrobacterium, Fluorescence, Leaves

Materials and Reagents

  1. Agrobacterium strain hosting a plant expression construct (usually driven by Cauliflower mosaic virus 35S promoter)
  2. Healthy Nicotiana benthamiana (N. benthamiana) plants 2-4 weeks
  3. MES
  4. MgCl2 stock
  5. Antibiotics
  6. Acetosyringone
  7. LB media with appropriate antibiotics (see Recipes)
  8. Acetosyringone stock (see Recipes)
  9. MES-K (see Recipes)
  10. Resuspension solution (see Recipes)
  11. Acetosyringone datasheet (Sigma-Aldrich) (see Recipes)

Equipment

  1. Centrifuge for 50 ml tubes
  2. Spectrometer
  3. Syringe
  4. UV lamp (optional)
  5. Fluorescence microscope (optional)
  6. Confocal laser scanning microscope (optional)

Procedure

  1. Inoculate one single colony of Agrobacterium in 5 ml LB with appropriate antibiotics. Grow overnight at 28-30 °C.
    Note: I usually use 100 μg/ml gentamicin (maintain the virulence of Agrobacterium strain GV3101) and 50 μg/ml spectinomycin (selective marker for shuttle vector) for most of the shuttle vectors.
  2. Use 1 ml of the overnight culture to inoculate 25 ml LB (with same antibiotics, plus 20 μM acetosyringone added after autoclaving and immediately before use) and grow overnight.
  3. Measure the A600 of overnight culture. 
  4. Precipitate the bacteria (5,000 x g, 15 min), resuspend the pellet in Resuspension Solution. The final A600 should be adjusted to 0.4. 
  5. Leave on the bench (room temperature) for 2-3 h (or overnight) before infiltration.
  6. Perform the infiltration with 5 ml syringe. Simple press the syringe (no needle) on the underside of the leaf (Note: Avoid cotyledons), and exert a counter-pressure with finger on the other side. Successful infiltration is often observed as a spreading “wetting” area in the leaf.
  7. (Optional) Check the GFP fluorescence by a portable long-wavelength UV lamp 2-5 days after infiltration. This only applies to strong expression of GFP signal (as green from red background).
  8. Observe the fluorescence labeled protein under a fluorescent microscope or confocal laser scanning microscope. Or harvest leaves for protein purification.

Recipes

  1. LB media with appropriate antibiotics
    Usually two antibiotics used: one to maintain Agrobacteria virulence, one for the shuttle vector
  2. Acetosyringone stock
    100 mM in ethanol, stored at -20 °C
  3. MES-K (0.5 M) (pH 5.6)
    First make 0.5 M MES, adjust pH with KOH to 5.6
  4. Resuspension solution
    10 mM MgCl2
    10 mM MES-K (pH 5.6)
    Autocloave 15 min
    100 μM acetosyringone (note: Added after autoclaving and immediately before using)
  5. Acetosyringone datasheet
    Synonyms     3’, 5’-Dimethoxy-4’-hydroxyacetophenone
    Synonyms     Acetosyringone
    4’-Hydroxy-3’, 5’-dimethoxyacetophenone
    Molecular Formula              C10H12O4
    Molecular Weight                196.20
    CAS Number                       2478-38-8
    Beilstein Registry Number   1966119
    EG/EC Number                   2196105
    MDL number                      MFCD00008748

References

  1. Li, X., Chanroj, S., Wu, Z., Romanowsky, S. M., Harper, J. F. and Sze, H. (2008). A distinct endosomal Ca2+/Mn2+ pump affects root growth through the secretory process. Plant Physiol 147(4): 1675-1689.


How to cite this protocol: Li, X. (2011). Infiltration of Nicotiana benthamiana Protocol for Transient Expression via Agrobacterium. Bio-protocol Bio101: e95. DOI: 10.21769/BioProtoc.95; Full Text



Reproducibility Feedback:

  • Add Photo
  • Add Video

Bio-protocol's major goal is to make reproducing an experiment an easier task. If you have used this protocol, it would be great if you could share your experience by leaving some comments, uploading images or even sharing some videos. Please login to post your feedback.

Q&A and Troubleshooting:

  • Add Photo
  • Add Video

Please login to post your questions/comments. Your questions will be directed to the authors of the protocol. The authors will be requested to answer your questions at their earliest convenience. Once your questions are answered, you will be informed using the email address that you register with bio-protocol.
You are highly recommended to post your data (images or even videos) for the troubleshooting. For uploading videos, you may need a Google account because Bio-protocol uses YouTube to host videos.


Login | Register